Opening training…
Search
Team
0
P03 knowledge check
Product Knowledge: Color, Joints & Repair
Pass is 80%. This is open-book — use the academy, not hope.
1. True or false: MavCoat products ship pigmented by default and MavTints are only for touch-up.
True
False
2. MavTints mix into which of the following?
MavCoat products only
MavSeal products only
MavCoat and MavSeal products at defined per-family load ratios
Water-based coatings only
3. True or false: MavTints are added directly into wet MavCrete UM cementitious urethane at the same load rate as into MavCoat SLE.
True
False
4. A customer supplies a RAL chip not on the standard chart. The Maverick color-match workflow is:
Refuse the job
Match to the closest stocked MavTints color, and if an exact match is required, order a custom MavTints color through the Maverick color lab
Order pigment from a third-party supplier
Use two MavTints packs and hope
5. True or false: MavTints ships in 16 oz cans, 7 stocked colors, at 100% solids with zero VOC.
True
False
6. For a 3-gal kit of 100% solids epoxy in White where hide is critical, the PDS recommends:
One MavTints pack (16 oz)
Two MavTints packs (2 × 16 oz)
Three MavTints packs (3 × 16 oz)
A gallon of pigment paste
7. MavJoint JF is intended for:
Expansion joints
Saw-cut control joints in industrial concrete floors
Cove-to-wall joints
Perimeter joints in freezers
8. True or false: MavJoint JF is designed to accommodate the movement of an expansion joint.
True
False
9. Over-filled MavJoint JF is trimmed:
Before cure, with a putty knife while wet
During cure, with a wet rag pull
After cure, flush to the slab with a sharp razor blade
It cannot be trimmed
10. True or false: a saw-cut left unfilled for years, then filled with MavJoint JF, performs identically to a joint filled fresh.
True
False
11. Recommended saw-cut prep before MavJoint JF:
Wet-cut, leave wet
Dry, dust-free, roughened sidewalls; remove any laitance
Prime with MavCoat SLE first
Fill loose debris with sand
12. A bull-nose spall on a loading-dock lip must receive a MavCoat topcoat within 4 hours — spec:
MavPatch Epoxy
MavRapidPatch
MavPolyPatch
MavGrout USP
13. True or false: MavPolyPatch feather-edges to a knife edge.
True
False
14. Walk-in freezer at 35°F, crew must patch a divot and topcoat before the room warms — the fastest patch is:
MavPatch Epoxy
MavRapidPatch
MavPolyPatch
MavGrout USP
15. True or false: MavPatch Epoxy typically requires overnight cure before receiving a topcoat.
True
False
16. Typical install temperature window for MavPatch Epoxy:
−20 to 40°F
32 to 60°F
50 to 90°F
90 to 130°F
17. True or false: MavRapidPatch is a magnesium phosphate cementitious repair.
True
False
18. A deep repair (over 1 in) under a MavCrete UM install, where you need mechanical bond and cementitious compatibility above — spec:
MavPatch Epoxy or MavRapidPatch
MavPolyPatch
MavJoint JF
MavGrout USP
Score quiz
Back to module
